Drill & cut oil 400ml L81 NBQ

Technical information

Drill & Cut oil

Special lubricating oil for various metalworking operations: drilling, cutting, threading, milling, etc. The product's good lubricating and cooling properties extend the life of the cutting blades and prevent the risk of tools jamming. The product is suitable for processing both hard and soft metals. The product is too thick for small diameter fine threading. In this case, it is reasonable to use PTFE Oil or PTFE Lube.

Processing metals of different strengths: drilling, cutting, milling, turning, etc.
• Storage, transportation and use temperature range from +5 ºC to +45 ºC.
• Shake the aerosol thoroughly before use.
• Make sure the surface is clean before spraying.
• Spray the product evenly onto the surface from a distance of 25 cm.
• The product can only be sprayed by holding the aerosol in an upright position.
Base materials mineral oils, high-load and anti-wear additives, various sulfur additives
Colour yellowish
Odour typical
Load resistance 4-Ball EP, Weld Load 4500N
Load resistance ASTM D665 OK
Base oil viscosity 40 ºC 475 cSt
Density 0.822g/ml
• Good thermal conductivity
• Extends the life of cutting blades
• Lowers cutting temperature
• Good surface stability